PGI User Forum

Hameda · Joined: 16 Dec 2009 Posts: 4

Hi everybody,

It's my first time to use vectorization in FORTRAN.
When I write the command for vectorization in the command window it prints out that the command is not valid.

Any idea?

Thanks,
Hamed

mkcolg · Posted: Thu Feb 11, 2010 5:49 pm Post subject:

Hi Hamed,

Unfortunately, I'm not quite sure what you mean. Can you please post example of the command that you are running and the error you are getting?

Thanks,
Mat

Hameda · Joined: 16 Dec 2009 Posts: 4

Hi Mat,

My command is the same I found in the manual:

-Mvect=sse

and I receive the error:

command is not valid

Even I tried to use the help command (–help) or fast (-fast), but I got the same error.

Thanks,
Hamed

mkcolg · Posted: Fri Feb 12, 2010 1:40 pm Post subject:

Hi Hameda,

Most likely your installation was not successful or was corrupted somehow. What OS and compiler version are you using? Did you notice any error during installation? Have the compilers worked in the past?

- Mat

Hameda · Joined: 16 Dec 2009 Posts: 4

Hi Mat,

Yes the compiler works well! I have done more than 50 programs!!
No error was reported during the installation.

The only thing that I worry, is that as the FORTRAN is being run inside the VS i think this command line just compiles VS commands and not FORTRAN??!

I'm using a PVF (education license) which I think is Ver 9. (I'm pretty sure t's not 10).

If you go to this link you can see a screen image of my computer while this error comes up.

http://web.mit.edu/hamed_al/www/FORTRAN.JPG

Thanks,
Hamed