PGI User Forum
 SearchSearch   MemberlistMemberlist     RegisterRegister   ProfileProfile    Log inLog in 

Free OpenACC Webinar

target architecture is not supported

 
Post new topic   Reply to topic    PGI User Forum Forum Index -> Debugging and Profiling
View previous topic :: View next topic  
Author Message
YunchengEric



Joined: 22 Jan 2010
Posts: 1

PostPosted: Fri Jan 22, 2010 7:05 pm    Post subject: target architecture is not supported Reply with quote

Hi,

pgdbg showed an error message "target architecture is not supported".

What am I supposed to do ?

I use the following command to run the mpi program with pgdbg

mpirun -np 4 -dbg=pgdbg programname

the program ran without stopping all the way to the end. It seems like the debugger
is not attached to the running program. When I used pgdbg directly and tried to attach
the program to it, it showed the error message that I mentioned above.

Any idea to fix it ?

Thanks,

Eric
Back to top
View user's profile
mkcolg



Joined: 30 Jun 2004
Posts: 6218
Location: The Portland Group Inc.

PostPosted: Fri Jan 22, 2010 9:14 pm    Post subject: Reply with quote

Hi Eric,

This typically means that you're using the 32-bit pgdbg with a 64-bit binary (or visa versa). Make sure the pgdbg in your PATH matches the mode of your binary.

- Mat
Back to top
View user's profile
Display posts from previous:   
Post new topic   Reply to topic    PGI User Forum Forum Index -> Debugging and Profiling All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © phpBB Group