PGI User Forum
 SearchSearch   MemberlistMemberlist     RegisterRegister   ProfileProfile    Log inLog in 

CUDA-x86.

How to properly install if eth0 is disabled?

 
Post new topic   Reply to topic    PGI User Forum Forum Index -> Licenses and Installation
View previous topic :: View next topic  
Author Message
Lukas Valin



Joined: 02 Jul 2007
Posts: 10

PostPosted: Wed Jul 25, 2007 12:55 pm    Post subject: How to properly install if eth0 is disabled? Reply with quote

Is that what I should use for my hostid? The card/drivers are bad, so it doesn't actually get network access. I actually have 4 ethernet cards installed, eth0 & eth1 are disabled.

I'm trying to install the lm* stuff.
Back to top
View user's profile
mkcolg



Joined: 30 Jun 2004
Posts: 6134
Location: The Portland Group Inc.

PostPosted: Thu Jul 26, 2007 10:12 am    Post subject: Reply with quote

Hi alspehr,

Flexlm on linux only reads the MAC address of eth0. We have no workaround for this. The alternatives are

1. Configure a network card at eth0, so that the license manager can support multiple usernames sharing the license.

2. Create a PGI-style license using the output of $PGI/linux86/7.0/bin/pghostid to allow one username only access to the compilers. (Note: run pghostid when logged in as that one username.)

Please contact license@pgroup.com for further assistance.

Best Regards,
Mat
Back to top
View user's profile
Display posts from previous:   
Post new topic   Reply to topic    PGI User Forum Forum Index -> Licenses and Installation All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © phpBB Group